STB PDF

Plastics piping and ducting systems. Injection-moulded thermoplastics fittings for pressure piping systems. Test method for maximum deformation by crushing. Original standard BS EN 00802-1995 (1999) BS 2782-11-Method 1114F-1995 in PDF full version. Additional info + preview on request

Document status: Active

Plastics piping systems. Injection-moulded thermoplastics fittings for elastic sealing ring type joints for pressure piping. Test method for resistance to a short-term internal pressure without end thrust. Original standard BS EN 00803-1995 (1999) BS 2782-11-Method 1123J-1995 in PDF full version. Additional info + preview on request

Document status: Active

Plastics piping systems. Injection-moulded socket fittings for solvent-cemented joints for pressure piping. Test method for resistance to a short-term internal hydrostatic pressure. Original standard BS EN 00804-1995 (1999) BS 2782-11-Method 1123K-1995 in PDF full version. Additional info + preview on request

Document status: Active

Pumps and pump units for liquids Common safety requirements. Original standard BS EN 00809-1998 + A1-2009 in PDF full version. Additional info + preview on request

Document status: Active

Personal fall protection equipment. Sit harnesses. Original standard BS EN 00813-2008 in PDF full version. Additional info + preview on request

Document status: Replaced by STB BS EN 813-2024

Original standard BS EN 00815-1996 in PDF full version. Additional info + preview on request

Document status: Active